Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 35)

Verifying Installation
PDR 100 Master Enhanced Disk Recorder 25
Verifying Installation
Verifying installation consists of ensuring that the system recognizes the Master
EDR board using the Profile Configuration Manager. The Profile Configuration
Manager graphic display shows all installed and recognized boards.
To check for Master EDR board recognition:
1. Power On the PDR 100 and logon.
2. Start Profile Configuration Manager using one of the following instructions
depending on your operating system:
- Windows NT 3.51 - Select PDR100 Applications program group and then
open Profile Configuration Manager .
- Windows NT 4.0 - Select Start | Programs | PDR Applications | Profile
Configuration Manager.
3. Look at the bottom of the Configuration Manager window to ensure
that Master DiskRec appears in the slot where you have installed the Master
EDR board. Refer to the example in Figure 20 on page 26.
NOTE: If you have a problem, refer to “If A Problem Occurs” on page 27
This completes the Master EDR installation procedure.