Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 23)

Reinstalling Board Retainer Brackets
PDR 100 Master Enhanced Disk Recorder 13
Reinstalling Board Retainer Brackets
Before re-installing the short board retainer bracket, check it against the lay-out of
the boards. Ensure that an extender is in every location where a short board is
installed and that none are in locations where full sized boards are installed.
NOTE: To prevent damage to the Analog Composite Monitor board, if
installed, ensure that an extender is not installed at the Analog Composite
Monitor board location.
To move a short board bracket extender:
1. Use the Torx tool with the T15 bit and remove extender retaining screw
(
Ê
in Figure 9) from the bracket.
2. Move the extender to the desired location on the bracket.
3. Ensure that the extender alignment nub is in the hole on the bracket and
replace retaining screw (
Ë
in Figure 9).
Figure 9. Short board retainer bracket and extender example
9674-6
1
2