Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 16)

Installation Procedures
6 PDR 100 Master Enhanced Disk Recorder
Removing the Circuit Board Hold-down Brackets
There are two hold-down brackets (shown in Figure 2) you must remove to access
the circuit boards. Use the procedure below to remove these brackets.
1. Using a Torx tool with a T10 tip, remove the screw (
Ê in Figure 2) which
secures the rear board hold-down bracket.
Figure 2. Removing the circuit board hold-down brackets
9674-13
1
3
4
2