Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 30)

Installation Procedures
20 PDR 100 Master Enhanced Disk Recorder
4. Refer to Figure 16 and replace the existing front panel cable and LED cable
assemblies with the new ones shipped with this kit.
Figure 16. Installing the new front panel cable and LED cable assemblies
5. Reinstall the front panel backing plate (see Figure 15 and 16).
6. Refer to Figure 13 and 14 and reinstall the front panel with its cables and
handles.
Installing the EMI Gasket
Installing the EMI gasket involves removing the power supply mounting screws
so that the power supply can be slid toward the front of the unit. This gives access
to the area where the EMI gasket will be installed.
To install the EMI foam gasket:
1. Use the Torx tool with the T10 tip to remove the four screws, shown as Ê in
Figure 17, which secure the power supply to the right side of the chassis.
9674-28