Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 31)

Installing EMI Compliance Components
PDR 100 Master Enhanced Disk Recorder 21
2. Refer to
Ë in Figure 17 and slide the power supply toward the front panel of
the chassis approximately 1 inch.
3. Remove the protective strip from the adhesive on the EMI gasket.
4. Carefully slip the gasket into the chassis between the power supply and the
rear panel and attach it to the chassis just below the power cord connector
cut-out as shown at
Ì
in Figure 17.
5. Slide the power supply back into its original position and secure it to the
chassis with the screws previously removed.
Figure 17. Installing the EMI gasket
0463-4
2
1
3