Grass Valley PDR 100 Master Enhanced Disk Recorder Board - Manual (Page 15)

Removing the Chassis Covers
PDR 100 Master Enhanced Disk Recorder 5
Removing the Chassis Covers
Use the following procedure to remove the chassis covers:
1. Turn off PDR100 power and remove the power cord.
2. Using a Torx tool with a T10 tip, remove the top screws from the front
chassis cover (
Ê in Figure 1). Remove the front cover. The front chassis
cover must be removed first because it overlaps the rear chassis cover.
NOTE: Take care not to lose the chassis screws—they are required to meet
EMI specifications for the PDR100 system. If your PDR 100 has been
upgraded to 9GB disk drives, it will have more disk drive cover screws than
shown in Figure 1.
Figure 1. Removing the chassis cover screws
3. Using a Torx tool with a T10 tip, remove the rear chassis screws and then
remove the rear cover (
Ë
in Figure 1).
2
1
9496-1