Grass Valley Kayak HD Installation v.6.9.4 Jun 02 2011 - Manual (Page 181)

Kayak HD — Installation and Service Manual 181
Additional Kayak Panel FRUs
Replacing a Lever Arm (2-M/E and 3-M/E)
To replace a Lever Arm , complete the following steps:
1. Remove the screw from each side of the Lever Arm “T” handle, as
shown in
Figure 132 .
2. Safely separate the top of the control panel enclosure from the bottom
(see
Removing the Top of the Control Panel Enclosure on page 168 ).
Figure 132. Kayak Control Panel Lever Arm—Removing Lever Arm “T” Handle
3. Remove the two sides of the handle.
4. Disconnect the cable from the Panel CPU board, as shown in
Figure 133 .