Grass Valley Kayak HD Installation v.6.9.4 Jun 02 2011 - Manual (Page 150)

150 Kayak HD — Installation and Service Manual
Section 4 — Maintenance
Manually Configure the SNMP Trap Destination
The trap destination is the target for all status messages delivered from the
Kayak system. To manually configure the trap destination you need the fol-
lowing information:
• The names of the SNMP communities to which the switcher belongs.
Typically, this is set to Public. If you use other SNMP community
names, make sure you set trap destinations for each one.
Note Kayak system supports at the time only Public (read only
access) and Privat (read/write access)
communities.
• The IP address of the NetCentral server PC which receives SNMP trap
information.
Note The NetCentral PC must be installed in the same Sub-Net as all Kayak devices
(control panel and video processing frame).
To check, add, edit, or remove trap destinations on the Kayak HD system:
1. Select the Install – Diagnosis menu.
NetCnt Trp IP and NetCnt Trp Comm. are displayed in the right list field.
2. Select Modify Trap Co button to enter the community name or select Modify
Trap IP to enter the IP address of the NetCentral PC.