Grass Valley Kaleido-MX 4K (1RU) v.7.80 - Manual (Page 38)

24
Operation
Remote Control Using iControl
* All output cards within a Kaleido-MX 4K frame must have their output heads configured with the same
refresh rate. If your frame is referenced, then the heads’ refresh rate must also match the reference signal's
refresh rate.
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
*** The Kaleido-MX 4K does not support converting an input module into a 4K UHD prescaler. The SFP ports
are not yet supported.
Remote Control Using iControl
The Kaleido-MX 4K may be controlled by using Grass Valley’s iControl version 4.43 or later.
This section describes the two control panels associated with the Kaleido-MX 4K’s input and
output cards and their use. Refer to the iControl User’s Guide for information about setting
up and operating iControl.
In iControl Navigator, iControl Web, or iControl Solo, double-click the icon for a
Kaleido-MX 4K input or output card (KMX-3901-OUT, or KMX-3901-IN-16-Q) to open the
associated control panel.
OUTPUT A IP EDIT ###.###.###.###
OUTPUT B IP EDIT ###.###.###.###
{POSITION}**
{MAC ADDRESS}**
Kaleido-MX 4K input card local menu
STATUS CARD STATUS {CARD STATUS}**
INPUT STATUS 1 {FORMAT}**
2 {FORMAT}**
3 {FORMAT}**
16 {FORMAT}**
CONFIG*** 4K UHD PRESCALER ENABLE
DISABLE
SFP CONFIG SFP OUT 1 ON
OFF
SFP OUT 2 ON
OFF
SFP OUT 3 ON
OFF
SFP OUT 4 ON
OFF
{CARD VERSION}**
Kaleido-MX 4K output card local menu (continued)
...