Grass Valley Kaleido-MX 4K (1RU) v.7.80 - Manual (Page 37)

23
Kaleido-MX 4K (1RU)
Hardware Description & Installation Manual
Press the CONTROLLER button on the control panel to select the controller card itself.
Navigating the Local Control Panel Menu
The Kaleido-MX 4K has operating parameters which may be adjusted locally at the
controller card interface. Press the Select button on the front edge of a Kaleido-MX 4K input or
output card (see
Card Button and LED Interface , on page 18) to assign the local control
panel to operate the card. The local control panel displays a menu that can be navigated
using the four buttons located next to the display. The functionality of the buttons is as
follows:
If no controls are operated for 30 seconds, the controller reverts to its normal standby
status, and the selected card’s Status LED reverts to its normal operating mode. If a
parameter was changed on the card but not submitted (SEL was not pressed) and the
30 second timeout occurs, the parameters will be confirmed as if the SEL button had been
pressed.
Local Control Panel Menu Structure
Where applicable, default values are underlined.
[+] and [-] Used for menu navigation and value modification.
SEL Gives access to the next menu level. When a parameter value is shown, pressing this
button once enables modification of the value using the [+] and [-] buttons;
pressing a second time confirms the new value.
ESC Cancels the effect of parameter value changes that have not been confirmed;
pressing ESC causes the parameter to revert to its former value.
Pressing ESC moves the user back up to the previous menu level. At the main menu,
ESC does not exit the menu system. To exit, press the Select button on the front
edge of the card being controlled.
Kaleido-MX 4K output card local menu
STATUS {CARD STATUS}**
{CARD VERSION}**
RESOLUTION HEAD1 {List of resolutions;* = current}**
HEAD2 {List of resolutions;* = current}**
{LINK STATE}**
FANS {CPU FAN STATUS}**
{FPGA FAN STATUS}**
NETWORK SETTINGS FRAME IP ADDRESS EDIT ###.###.###.###
NETMASK EDIT ###.###.###.###
DEFAULT GW EDIT ###.###.###.###
LINK MODE EDIT Auto-negotiate
100Mbps half-duplex
100Mbps full-duplex