Grass Valley Kaleido-MX 4K (1RU) v.7.80 - Manual (Page 18)

4
Installation
Frame Interface
Rear of the Kaleido-MX 4K 16 × 1 frame
The rear of the Kaleido-MX 4K (1RU) frame is organized in three sections, matching the
front.
Viewed from the back of the frame, the three sections are laid out as follows:
Kaleido-MX 4K systems with 16 inputs share the same rear-panel as the Kaleido-MX 16 × 4
multiviewer model, including 16 input connectors, 4 HD-SDI monitoring outputs, 1 SDTI
audio input, 1 LTC input, 1 reference input, 2 Ethernet connectors, 1 RS-422 connector,
20 GPI inputs, and 8 configurable GPI input/output.
Kaleido-MX 4K 16 × 1 rear panel
Right This area contains inputs and outputs for the controller
card: the fan speed control setting switch, a GPI port and
two Ethernet ports. It also contains the power socket for
the power supply located beneath the controller card,
and one of the two frame fans.
Center This area contains the connectors associated with your multiviewer’s input and
output cards.
Left This area contains the power socket for the power
supply located beneath the GPI-1501 card, and one of
the two frame fans.
Note: The Kaleido-MX 4K (1RU) offers a wide variety of ports for incoming
and outgoing signals. With a view towards future expansion, there are ports
whose connections exist but that are currently not fully supported. The
FlexBridge IN ports are reserved for future expansion, and the SFP ports are
not yet supported.
Notes
• Do not use the 4 HDMI outputs with this system configuration. A seamless
4K UHD output is only supported at the SDI OUT connectors.