Grass Valley K2 Dyno Replay Controller - Manual (Page 38)

38 K2 Dyno Replay Controller Service Manual June 16, 2009
Chapter 2 Service Procedures
The recovery disk image process that you should follow is summarized in the
following steps.
At the Dyno controller first birthday…
1. Boot from the Recovery Flash Drive..
2. Create a recovery disk image for the Dyno controller.
At milestones, such as software upgrades…
1. Boot from the Recovery Flash Drive..
2. Create a recovery disk image for the Dyno controller.
3. Copy the disk image to another location, such as a network drive.
If you need to restore the Dyno controller…
1. Boot from the Recovery Flash Drive..
2. Read the disk image from the Recovery Flash Drive or from the location that you
stored the disk image.
Use the following procedures to implement the recovery disk image process as
necessary.
Creating a recovery disk image
Do the following at the local Dyno controller to create a disk image:
1. Make sure that media access is stopped.
2. If you have not already done so, connect keyboard, monitor, and mouse to the Dyno
controller.
3. Insert the Recovery Flash Drive into a USB port and restart the machine.
The machine boots from the Flash drive. The Acronis True Image program loads.
4. In the Acronis True Image main window, click Backup .
The Create Backup Wizard opens.
5. On the Welcome page, click Next .
The Partitions Selection page opens.
6. Select the (C:) partition and then click Next .
If a “…choose full backup mode…” message appears, click OK .
The Backup Archive Location page opens.
7. In the tree view select Removable Drive (A:) as the location to which you are writing
the disk image.
8. Enter the name of the image file you are creating. Create the file name using the
Dyno controller hostname and the date. Name the file with the .tib extension. For
example, if the hostname is Dyno1, in the File name field you would have
E:\Dyno1_20091027.tib
. Click Next .
The Select Backup Mode page opens.
9. Select Create a new full backup archive . Click Next .