Grass Valley K2 Dyno Replay Controller - Manual (Page 28)

28 K2 Dyno Replay Controller Service Manual June 16, 2009
Chapter 1 Product Description
FRU functional descriptions
The Field Replaceable Units (FRUs) described in this section are as follows:
• “Base chassis”
• “Compact Flash boot media”
• “Jog knob”
• “Plastic cover”
• “T-bar lever assembly”
• “Control panel UI board”
• “LCD screen”
• “LCD screen inverter board”
• “Front I/O board”
• “Fan”
• “USB board”
• “Motherboard”
• “Power supply”
For procedures, refer to Chapter 4, Removing and replacing FRUs.
Base chassis
For some serious system faults or for mechanical damage, the entire Dyno controller
can be replaced as a base chassis FRU. Refer to
“Replacing a Dyno controller” on
page 40 .
Compact Flash boot media
The Compact Flash boot media contains the system drive, also known as the C: drive.
The C: drive contains application and operating system files.
Refer to “Compact Flash boot media removal” on page 55 for procedures.
Jog knob
The jog knob is 60mm, weighted, and rubber encased with tactile relief.
Refer to “Job knob removal” on page 54 for procedures.
Plastic cover
The plastic top cover provides the finished work surface with access holes for
controls.
Refer to “Plastic cover removal” on page 58 for procedures.