Grass Valley K2 Dyno Replay Controller - Manual (Page 36)

36 K2 Dyno Replay Controller Service Manual June 16, 2009
Chapter 2 Service Procedures
Upgrading software
When you receive your Dyno controller from Grass Valley, it has all necessary
software installed. For procedures to upgrade software on the Dyno controller, refer
to the K2 Dyno Replay Controller Release Notes for the version to which you are
upgrading. Also refer to K2 Release Notes to upgrade related software on the K2
Summit Production Client.
Updating firmware
1. Copy the update file to a USB memory.
• For instructions on how to obtain the update file, see the latest release notes.
2. Attach the USB memory to the K2 Dyno Replay Controller.
3. As soon as the K2 Dyno Replay Controller starts up, press the Fn , Shift , and A
buttons at the same time.
• You can also start the firmware updater by double-clicking
ControllerUpdater.exe in c:/program files/K2Dyno.
4. Click Update .
• If you click Backup , the current program is backed up to the folder where the
program was installed.
T-BAR Sets the idle of the T-Bar. Operate the T-Bar to move it to the position you want to
set as 0%, and then touch “0%”. Similarly, touch “100%” at the position to set as
“100%”
JOG Sets the idle of the JOG knob. Touch to adjust. The idle becomes smaller as
you decrease the value.
Load Default Touch to restore the default settings.
Save & Exit Saves the settings and exits the calibration screen.
Exit Discards the settings and exits the calibration screen.
Touch this… To make this adjustment: