Grass Valley K2 Dyno Replay Controller - Manual (Page 35)

June 16, 2009 K2 Dyno Replay Controller Service Manual 35
Chapter
2
Service Procedures
Topics in this section include the following:
• “Exporting log files” on page 35
• “Calibrating the control panel” on page 35
• “Upgrading software” on page 36
• “Updating firmware” on page 36
• “Using recovery disk images” on page 37
• “Replacing a Dyno controller” on page 40
Exporting log files
1. In the K2 Dyno Replay application on the K2 Dyno Replay Controller LCD screen,
select the CONFIG tab.
2. Touch < or > and then select LOG .
3. Configure settings as follows:
• Verbose Level — Sets the log output level. A more detailed log is output as you
increase the value.
• Output Folder — Specifies the folder to which the log is output.
• Gathering From — Sets the source(s) from which a log is collected. If you select
Local Only, a log for operations, only on the K2 Dyno Replay Controller that
you are currently working on, is output. If you select Session, a log for
operations on all the controllers is output even when multiple K2 Dyno Replay
Controllers are connected.
Calibrating the control panel
You can adjust the LED brightness of the button and the idle of the T-Bar/JOG knob
to suit your environment or preferences.
1. Press the Shift , Fn , and Next buttons at the same time.
The calibration screen appears on the LCD screen.
2. Set items as follows:
Touch this… To make this adjustment:
TOUCH PANEL Corrects the touch panel. Touching the panel displays cross-shapes at the upper
left and lower right corners of the screen. Touch them to correct the touch panel,
respectively.
LCD BRIGHT Adjusts the screen brightness. Touch to adjust.
LED BRIGHT Adjusts the button brightness. Touch to adjust.