Grass Valley K2 Dyno PA Configuration Manual v.2.0 - Manual (Page 37)

1. When adding a new or replacing an existing K2 Summit system in a K2 Dyno PA system, the
FsNameServers file in the C:\SNFS\Config folder must be identical to the other FsNameServers
files in the system. This file contains the IP addresses of the Control network ports on up to three
name servers. You do not need to disable the Write Filter to edit the FsNameServers file.
• If adding or replacing a K2 Summit system that is not being used as a host name server, copy
the FsNameServers file from one of the other machines in the setup to the C:\SNFS\Config
folder of the new machine.
• If replacing a K2 Summit system that is used as a host name server, the same IP address for
the Control network can be used on the replacement machine. Since the identical
FsNameServers file already exists on the other K2 Summit systems or Dyno PA machines,
copy the existing FsNameServers file from one of these to the replacement machine.
• If adding a new host name server to an existing K2 Dyno PA system, the IP address of the
Control network for the new machine needs to be added to the FsNameServers file of all the
K2 Summit systems and Dyno PA machines in the current setup. Either add this IP address
to all the FsNameservers files or update one FsNameServers file and then copy that file to
the other machines. You can have up to three host name servers in a setup.
2. Reboot the K2 Summit systems.
3. Reboot the K2 Dyno PA machines.
Related Links
Managing K2 Dyno PA on page 31
Restoring the K2 Summit system to a pre-DLC configuration
If you need to roll a K2 Summit system back to its pre-DLC configuration, you can undo the changes.
Related Links
Managing K2 Dyno PA on page 31
Restoring the network adapter order on page 37
Undoing the DLC server configuration on page 38
Restoring the network adapter order
To restore the network adapter order to its pre-DLC configuration, the Loopback adapter needs to
be the first adapter on the K2 Summit system.
1. Turn the write filter off.
2. On the Windows desktop right-click My Network Places and select Properties .
The Network Connections window opens.
3. On the menu bar at the top of the window, select Advanced , then Advanced Settings …
4. On the Adapters and Bindings tab, order adapters as follows:
a) Loopback adapter
b) Control network
c) Media network
5. To close Advanced Settings and accept the changes, click OK .
22 June 2011 K2 Dyno Production Assistant Configuration Manual version 2.0 37
Managing K2 Dyno PA