Grass Valley K2 Dyno PA Configuration Manual v.2.0 - Manual (Page 19)

6. If you are planning to use the Browse feature of the Dyno PA, proceed to Editing the
FsNameServers file on the Dyno PA PC in the K2 Dyno Production Assistant Configuration
Manual.
Related Links
Configuring the standalone K2 Summit system and K2 Dyno PA on page 9
Managing K2 Dyno PA on page 31
Editing the FsNameServers file on the Dyno PA PC with a standalone K2
Summit system
To use the Browse feature with a standalone K2 Summit system, the FsNameServers file on the
Dyno PA PC needs to contain the Control IP addresses of the host name servers, as described in
About the FsNameServers file.
1. In the Dyno PA application, select SNFS Settings from the menu.
The SNFS Configuration dialog box displays.
2. Enter the Control IP address of the host server and click Add .
The IP address is displayed under Host.
3. When you have finished adding host name servers (up to three), click Close .
Related Links
Configuring the standalone K2 Summit system and K2 Dyno PA on page 9
Enabling SNFS on the K2 Dyno PA PC in a standalone K2 Summit system
Prerequisites:
• The standalone K2 Summit system must have been configured as described in the section on
configuring your K2 Summit system.
• A K2 system must have been added to the Dyno PA client as described in Adding a standalone
server.
• The K2 Dyno PA machine must have the requirements described in the K2 Dyno PA Prerequisites
in the K2 Dyno PA Release Notes.
• The K2 Dyno PA machine must have the identical FsNameServers file as the K2 system. For
more information, see Configuring the standalone K2 Summit system and K2 Dyno PA .
To enable the Browse feature on the K2 Dyno PA application to work with a K2 Summit system,
the K2 Summit system needs to be configured for K2 Dyno PA and the SNFS software needs to be
configured on the Dyno PA machine. This section describes configuring SNFS software for the
DLC client on the Dyno PA machine.
1. If you do not already have the K2 Dyno PA application open, start it now.
2. Right-click on the K2 Summit system in the Navigation pane, and select Edit Server .
The Add/Edit Server Device dialog box displays.
3. In the Add/Edit Server Device dialog box, check the Enabled box.
4. Click the SNFS Configuration button.
22 June 2011 K2 Dyno Production Assistant Configuration Manual version 2.0 19
Configuring the standalone K2 Summit system and K2 Dyno PA