Grass Valley DD35 Family v.3.4.5 User Manual
Page 59
Supplement Software Release V3.4.5
DD35 Production Switcher
55
Operating Instructions – Rev. 0 / 7.2002
Depending on the operational mode, the parameters in the right part of the window
have a different meaning:
Normal VTR:
In:
not used for record or play, can only be used as Mark with
“goto Mark In”
Out:
not used for record or play, can only be used as Mark with
“goto Mark Out”
RecLen:
record length for record (00:00:00 is unlimited)
AutoCue:
not yet supported in the SW–option
Loops:
not used here
In this mode you can access the total TCrange of a channel or cascade. Recording
starts at the actual timecode and continues for the number of frames indicated in
“RecLen”.
Clip mode:
In:
start of the clip
Out:
end of the clip
not used:
not used
AutoCue:
not yet supported in the SW–option
Loops:
not used here
All tape motion commands are limited to the TC range within In and Out timecode.
A play command will automatically play from In to Out point.
Simple Loop:
In:
start of the loop
Out:
end of the loop
not used:
not used
AutoCue:
not yet supported in the SW–option
Loops:
number of loops, 0 is endless
All tape motion commands are limited to the TC–range within In– and Out–time-
code. A play command will automatically play from In– to Out–point and repeat this
for the number of loops.
Operational Mode