Grass Valley DD35 Family v.3.4.5 - Manual (Page 58)

Supplement Software Release V3.4.5 DD35 Production Switcher
54 Operating Instructions – Rev. 0 / 7.2002
By clicking the numbers 1, 2, 3, 4 under the title “RAM–1”, etc. you can cascade
2, 3, or 4 channels. By this the resulting time of the combined channels is accord-
ingly increased. To decascade the channels, just click again on the according num-
bers or click the title “RAM–1” etc.
The following rules apply to cascading:
D
The channel with the lowest number is always the master channel. Video input,
video output, operational mode, and readout is used from this channel.
D
When you use tape motion commands, the cursor can be positioned on any
RAM recorder of the cascade.
D
In Clip mode, Simple Loop mode, and Extended Loopmode the In and Out
points of the selected RAM recorder are used which allows more In and Out
points in cascade mode (see just below).
Cascading Channels