Grass Valley DD35 Family v.3.4.5 - Manual (Page 56)

Supplement Software Release V3.4.5 DD35 Production Switcher
52 Operating Instructions – Rev. 0 / 7.2002
3.3.2 DIALOG BUTTONS
Select source for selected channel
Note: Channel 1 and channel 2 are fed with the same signal.
Channel 3 and channel 4 are fed with the same signal.
Move cursor for selected machine up/down
Start Goto to start of timecode (or Mark In point if in clipmode,
loopmode).
End Goto to end of timecode (or Mark Out point if in clipmode,
loopmode).
Timecode Goto to entered timecode.
Mark In Goto to Mark In point.
Mark Out Goto to Mark Out point.
Auto Cue Switch Auto Cue On/Off (not yet supported in this SW–version).
Loops Number of loops for “Simple Loop” or “Extended Loop” mode
Readout set readout for still and for play (see detailed description
“Readout”).
Mode Set operational mode of RAM recorder channel.
Mark In Set Mark In point.
Mark Out Set Mark Out point.
Offset Set offset.
This value is used different purposes, depending on the
operational mode of the RAM recorder.
Copy actual timecode to Mark In point.
Copy actual timecode to Mark Out point.
Variable: Set RAM recorder to variable speed and allow speed change
by digipot.
Jog: Set RAM recorder to jog mode and allow jogging by digipot.
Goto to start of timecode (or Mark In point if in clipmode, loopmode).
Source
Up / Down Arrow
Goto
Settings
Grab Mark In
Grab Mark Out
Settings
Start