Grass Valley 3430AP CopperHead User Manual
Page 27
15
CopperHead 3430AP
User Manual
A) Optical Connector
See this Page
B) Audio/Data Indicators
C) Video/Data Indicators
D) Signal Strength Indicators/Setup
E) Status/Power Indicators
Area A – Front Panel Optical Connector (Optional)
Area A of the Copperhead 3400 Base Station provides for the optional mounting of the Fiber
Optical Connector on the front of the Base Station instead of the rear of the Base Station. Front
mounting of the optical connectors is normally specified at the time of ordering. Area A is
provided with a blank panel when the normal rear mounting of the fiber connectors is specified.
The Copperhead 3400 Base Station for use with the CopperHead
3430AP Camera Unit is normally delivered with two ST Fiber Optical
connectors for connection to the HDX-Plus power supply.
As noted above existing Copperhead 3400 Base Station units with
other types of connectors can be used with the 3430AP system with
the addition of Fiber Connector jumper cables connecting ST connec-
tors to one of the panel mounted connector types shown below.
Please consult Grass Valleysupport for information regarding the
appropriate jumper cable.
The Copperhead 3400 Base Station may also be equipped with one of these other types of Fiber
Connector. These types of connector are not normally specified for a new CopperHead 3430AP
system.
Neutrik OpticalCOM
SMPTE 304M
ST/UPC with 5Pin Molex
MX
Fig. 2-6: Fiber Connector Types
aaa
ST/UPC