Grass Valley 3430AP CopperHead User Manual
Page 25
13
CopperHead 3430AP
User Manual
Area I – Power Indicators, and Fan Control Switch and Indicators
Power Indicators
31 POWER IN
•
BRIGHT GREEN – CopperHead 3430AP Cam-
era Unit is switched on and the HDX-Plus is
operating at normal voltage
•
DIMLY LIT GREEN – CopperHead 3430AP
Camera Unit is switched off and the HDX-Plus
is operating at standby voltage
32 CAMERA OUT
•
BRIGHT GREEN – CopperHead 3430AP Cam-
era Unit is switched on and the HDX-Plus is operating at normal voltage. The camera is
receiving normal voltage.
33 OVERLOAD
•
BRIGHT RED – Maximum rated power output is reached
•
FLASHING RED – Maximum rated power output is exceeded – the CopperHead 3430AP
unit will shut down to protect the system and must be power cycled either at the Camera
Unit or the HDX-Plus to restart the system.
Fan Operations
34 Fan Control Switch
Push switch selects between three settings; the
LED corresponding to the selection is illumi-
nated:
•
MAX – Fan Speed is continuously at maxi-
mum speed
•
NORMAL – Fan Speed initially set to lowest
speed and then adjusts based on unit inter-
nal temperature – the temperature is never
allowed to be close to the unit maximum
operating temperature.
•
QUIET – Similar to NORMAL setting except that the temperature IS allowed to be close to
the unit maximum operating temperature.
35 MAX Indicator
Fan is operating at full speed.
36 NORMAL Indicator
Fan is operating in Normal mode and speed increases from minimum speed to full speed