beautypg.com

Specifications – Grass Valley 8990ARC v.1.0 User Manual

Page 23

background image

8990ARC Instruction Manual

17

Specifications

Specifications

Table 5. 8990ARC Specifications

Parameter

Value

SDI Input

Signal type

SMPTE 259M-C or EBU tech 3267, 8 or 10-bit serial digital component video

Number of inputs

1 loop-through

Connector type

75

BNC

Return loss

> 15 dB, 5 to 270 MHz

Max input cable lengthl

225 m (984 ft) of Belden 8281 or equivalent

SDI Outputs

Number of outputs

4

Connector type

75

BNC

Signal type

SMPTE 259M-C or EBU tech 3267

Output impedance

75

Return loss

> 15 dB, 5 to 270 MHz

Signal Processing

Signal path

12-bit processing internally then rounded and truncated to 10 bits

525/625 selection

Automatic

Aspect ratio selection

16:9 to 4:3, 4:3 to 16:9, manual or automatic if video index or WSS input is
enabled

Modes 16:9 to 4:3 conversion

• No processing
• Letter-box (no loss)
• Full height (h-crop)
• 14:9 sub-image (some h-crop, less than full height)

Modes 4:3 to 16:9 conversion

• No processing
• Side panels (no loss)
• Full width (v-crop)
• 14:9 sub-image (some v-crop, less than full width)

Horizontal position

Left/center/right justified output (shrink) or input (magnify)

Vertical position

Top/center/bottom justified output (shrink) or input (magnify)

Horizontal ancillary data

All horizontal embedded ancillary data (HANC) passed to output

Hot switch handling

Module will handle input signal hot switched between synchronous signals that
are timed within the same line without causing glitches in the output stream

Switching line processing

None

Vertical interval blanking

Vertical interval active line time data optionally replaced by black or blanking –
20 or 21 lines blanked for 525; 25 lines blanked for 625 signals

Active line blanking

Top and bottom 0, 1, 2, or 3 lines
In 525: Field 1 – 21 to 23 and 263 to 261; Field 2 – 20 to 22 and 262 to 260
In 625: Field 1 – 23 to 25 and 310 to 308; Field 2 – 336 to 338 and 623 to 621

Output signal EDH

Error Detection Handling (EDH) check-words per SMPTE RP 165 inserted in
output signal

Performance

Electrical length

75.25 lines all modes

Response to input signal loss

Output signal is invalid