Grass Valley 8990ARC v.1.0 - Manual (Page 14)

8 8990ARC Instruction Manual
8990ARC SD Aspect Ratio Converter
Onboard Configuration Switches and LEDs
The 8990ARC module can be configured using the rotary and paddle
switches shown in
Figure 5 . The CONF LED is a configuration status indi-
cator. These three components perform the following:
■ Function (rotary) switch — Addresses one of 16 possible positions (0
through 9 and A through F) to access a desired function for configura-
tion. Not all positions are used (see
Table 4 ).
Note The Function switch should be kept in position 0 when not in use to avoid any
inadvertent change in configuration. 0 is an inactive position.
■ SW1 (paddle) switch — Actuates or selects the desired setting for the
selected function when the switch is held momentarily in either the Up
or Down position.
■ CONF (configuring) LED — When on, indicates the module is initial-
izing or processing configuration information.
Figure 5. Module Configuration Switches and LEDs
Local On-board Module Configuration
The 8990ARC offers a choice between 4:3 and 16:9 video signal output
formats and one of four picture conversion modes for each format, see
Table 4 ). The various signal processing and content options are listed in the
table and can also be addressed using the Remote Configuration and Mon-
itoring GUI (see
Remote Configuration and Monitoring on page 13 ).
Note When module power recycles the last setup state is restored. The module
does not revert to a factory or the user default.
FUNCTION – rotary switch
SW1 – actuator toggle switch
CONF – configuration LED
JP2
Place jumper in
local position to
lock out remote
access.
Local
Local &
Remote
JP2
Remote Lockout
8036
_
06