Grass Valley 8981NR - Manual (Page 18)

18 8981NR Instruction Manual
Configuration
8981NR Module Onboard Configuration Settings
To make a configuration setting:
1. Rotate the Function switch to Bank 1 (2ND LED off) or Bank 2
(2ND LED on), then to the desired function within that bank.
2. Move the paddle switch to the up or down position and hold
momentarily to set the desired function (refer to
Table 4 ).
Note Holding the paddle switch in the up or down position for more than a half
second will automatically accelerate through the value range for parameters
with 256 or more values. The full range can be accessed in about 10 seconds.
3. Refer to Configuration Summary on page 13 for an overview of each
function. Table 3 on page 16 also gives a summary of value ranges, step
sizes, default values, etc. for each function