Grass Valley 8981NR - Manual (Page 11)

8981NR Instruction Manual 11
Power Up
Power Up
The front LED indicators and configuration switches are illustrated in
Figure 4 . Upon power-up, the green PWR LED should light and the yellow
CONF LED should illuminate for a few seconds for the duration of module
initialization.
Operation Indicator LEDs
With factory default configuration and a valid input signal connected, the
green PWR LED and one of the green signal standard LEDs (525 or 625)
should illuminate (refer to
Table 2 on page 12 to see the possible operating
indicator combinations).
Figure 4. LEDs and Configuration Switches
FUNCTION
FA
U
LT
525
625
2ND
UP
DOWN
INPUT
PRESENT
DELA
Y
COMM
CONF
PWR
8226_05
2ND LED
PWR – Green LED on indicates power OK.
FAULT – Red LED is off during normal operation.
COMM – Yellow LED on indicates frame bus traffic.
CONF – Yellow LED on indicates module is initiating,
changing operating mode, or updating firmware.
525 – Green LED on indicates 525 input present.
625 – Green LED on indicates 625 input present.
Module Configuration Switches and LEDs.