Grass Valley 8981NR - Manual (Page 15)

8981NR Instruction Manual 15
Configuration
Proc Amp Controls
When the video processor is enabled, the following independent adjust-
ments can be made to the SDI video signal:
• Y, B-Y, and R-Y offset, and
• Y, B-Y, and R-Y gains.
When the Gain Lock control is enabled, all three channels will change gain
by the same amount when any of the channel’s gain settings are adjusted.
When disabled, all processing is bypassed and when re-enabled, the pre-
vious settings are in effect.
Vertical Ancillary Line Controls
The module provides controls for blanking all vertical ancillary data (Yes
or No in remote or VANC Pass or VANC Blank in local mode). When
blanking is enabled on all lines, in 525 mode only, the blanking width can
be set to line 20 or line 21 (blank line 21 – Yes or No in remote or set blanking
width to line 20 or line 21 in local mode).
All horizontal interval data is passed to the output without processing.
Recall or Save Settings
The current module settings can be saved or recalled into/from one of four
memory registers. All controls, except the test modes, will be stored.