Grass Valley 8910ADA-M - Manual (Page 34)

34 8910ADA-M/ST/SR — Instruction Manual
Module Configuration
When Local/Remote control is enabled (onboard jumper J4 is set to
LOC/REM as shown in
Figure 11 on page 24 ), the Audio Status/Controls
web page shown in Figure 17 on page 35 will be available.
Gain adjustment mode can be set in one of two Stereo/Dual modes:
• Gain/Balance ( Figure 17 on page 35 ), or
• Independent Gain ( Figure 18 on page 36 ).
Gain/Balance Mode
In Gain/Balance mode, the gain median point is set in the gain window
(from -20 to +30 dB). The balance window allows a balance adjustment of
plus or minus 6 dB for each channel with 12 dB total difference in gain
between the channels at ± 6 dB balance setting. Gain and balance adjust-
ments are in 0.1 dB increments.
Note Non-zero balance value entries will preclude full range of Gain adjustment.
Note Gain value entries within 6 dB of -20 dB or +30 dB will preclude full range of
balance adjustment.
A negative value entered in the balance window raises Input 1 level by the
gain in the balance window and lowers Input 2 level by the same amount.
A positive entry does the opposite.
Table 5 provides the mid-point and
maximum balance adjustments possible using the 3.5 gain setting shown in
Figure 17 on page 35 .
Table 5. Balance Adjustments Resulting Gain Measurements for 3.5 dB Gain Entry
Balance Value Input 1 Gain Input 2 Gain
-6 +9.5 dB -2.5 dB
0 3.5 dB 3.5 dB
+6 -2.5 dB +9.5 dB