beautypg.com

Rear module installation – Grass Valley 8910ADA-M User Manual

Page 14

background image

14

8910ADA-M/ST/SR — Instruction Manual

Installation

Rear Module Installation

To install a rear module into GeckoFlex frame, follow these steps:

Note

Please read

Module Installation Precautions on page 13

before installing the

rear module.

1.

Each 8900A-R rear module or blank rear adapter cover is held in place
by two retainer clips as shown in

Figure 3

. Loosen (but do not remove

completely) the two screws holding each retainer clip to the frame with
a 2 mm (5/64”) hex screwdriver. Pull up on the retainer to remove it,
leaving the screws in place.

CAUTION Be careful to leave the screws in place as they can be easily lost or fall into

equipment below the frame creating a shorting hazard.

2.

Remove the blank rear adapter cover by inserting needlenose pliers
into the slots in the top and bottom of the blank and pulling it off.

Note

To remove a rear module already installed, follow the same steps. It is helpful
to first remove the front module so the rear can be pulled out more easily.

3.

Insert the rear module into the empty slot.

4.

Replace each retainer clip over the two screws on both sides of the
module and push down to seat the retainer.

5.

Tighten the screws for each retainer clip just until they are snug. Do not
force or torque the screws too tightly. The rear retainer clip screw torque
specification is 4-5-inch-lb./0.45-0.60Nm.

Figure 3. Installing Rear Module

Use needlenose pliers
to pull out blank after
removing retainers.

This manual is related to the following products: