Audio status/controls web page – Grass Valley 8910ADA-M User Manual
Page 32
32
8910ADA-M/ST/SR — Instruction Manual
Module Configuration
Audio Status/Controls Web Page
Use
this
link
The Audio Status/Controls web page allows you to perform the following
function for the 8910ADA-SR:
•
Monitor actual gain levels for each channel (a function of Gain and Bal-
ance) in both local and remote modes,
•
Select Gain and Balance adjustment mode – Gain/Balance or Indepen-
dent Gain,
•
Set Gain and Balance levels,
•
Select Normal or Inverted input, and
•
Select output mode – Input 1, Input 2, or - 6 dB Sum of both inputs.
Click the
Apply
button to activate a selection.
When
YES
is reported in the input monitoring information (Input 1 and
Input 2 Present), a signal of greater than -40 dBu has been detected at the
input. When the input detected is less than -40 dBu,
NO
is displayed.
If the onboard jumper for Local/Remote operation is in the LOC/POT
position (see
), the Audio Status/Controls display will
be in read-only mode (see
) and only local onboard
control is enabled. When set for Local control only, setting of overall gain
and balance is done using the front paddle switches on the module and for
fine gain and balance adjustment, the hard-wired customer-supplied
potentiometers connected to BNCs J11 and J12 can be used.
When in LOC/POT mode, the Audio Status Controls web page will con-
tinue to report the changes made with the local controls. The user must
manually refresh the page using the
Refresh
button at the top of the web
page each time a change is made with a local control for the web page to
update to the current local settings.
A
Fault
text message will appear for the Gain or Balance Potentiometer
status if no potentiometer is detected. When potentiometers are detected,
the status will report
Present
as shown in
.
Note
Fault reports for the hard-wired potentiometers are not reflected on the Frame
Status web page.