H3C Technologies H3C SecPath F1000-E - Manual (Page 51)

7
To do… Use the command… Remarks
Set the password for the local user
password { cipher | simple }
password
Required
The password of the authenticator
user must be the same as that of
the authenticatee user.
Configure the service type of the
local user as PPP
service-type ppp Required
NOTE:
If the authenticator name is configured, do not configure the ppp chap password command on the
interface that connects the authenticatee. Otherwise, the authentication may fail.
Configuring CHAP authentication when no authenticator name is configured
1. Configuring the authenticator
Follow these steps to configure the authenticator:
To do… Use the command… Remarks
Enter system view system-view —
Create a VT interface and enter VT
interface view
interface virtual-template number —
Configure the local device to
authenticate the peer by using CHAP ppp authentication-mode chap
[ [ call-in ] domain isp-name ]
Required
By default, PPP
authentication is disabled.
Return to system view quit —
Create a local user account for the
authenticatee and enter local user view local-user username
Required
Set the password for the local user
password { cipher | simple }
password
Required
Set the service type of the local user to
PPP
service-type ppp Required
Return to system view quit —
Create an ISP domain, or enter an
existing ISP domain view
domain isp-name
Optional
To configure the ppp
authentication-mode
command with an ISP
domain specified which is
not the default domain
system, configure this
command before
configuring the ppp
authentication-mode
command.
Configure local authentication for the
PPP users
authentication ppp local Optional
2. Configuring the authenticatee