H3C Technologies H3C SecPath F1000-E - Manual (Page 26)

10
To do... Use the command... Remarks
Set the system LACP priority
lacp system-priority
system-priority
Optional
By default, the system LACP priority
is 32768.
Changing the system LACP priority
may affect the aggregation state of
the ports in a dynamic aggregation
group.
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
interface
bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Configure the aggregation group
to work in dynamic aggregation
mode
link-aggregation mode
dynamic
Required
By default, an aggregation group
works in static aggregation mode.
Exit to system view quit —
Enter Layer 2 Ethernet interface
view interface interface-type
interface-number
Assign the Ethernet interface to the
aggregation group port link-aggregation group
number
Required
Repeat these two steps to assign
more Layer 2 Ethernet interfaces to
the aggregation group.
Assign the port an aggregation
priority link-aggregation
port-priority port-priority
Optional
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the dynamic aggregation group.
Configuring a Layer 3 dynamic aggregation group
Follow these steps to configure a Layer 3 dynamic aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Set the system LACP priority
lacp system-priority
system-priority
Optional
By default, the system LACP priority
is 32768.
Changing the system LACP priority
may affect the aggregation state of
the ports in the dynamic
aggregation group.