H3C Technologies H3C SecPath F1000-E - Manual (Page 49)

5
To do… Use the command… Remarks
Set a password for the local user
password { cipher | simple }
password
Required
Configure the service type of the
local user as PPP
service-type ppp Required
Return to system view quit —
Create an ISP domain or enter an
existing ISP domain view
domain isp-name
Optional
To configure the ppp
authentication-mode command
with an ISP domain specified
which is not the default domain
system, configure this command
before configuring the ppp
authentication-mode command.
Configure local authentication for
the PPP users
authentication ppp local Optional
Configuring the authenticatee
Follow these steps to configure the authenticatee:
To do… Use the command… Remarks
Enter system view system-view —
Create a VT interface and enter VT
interface view
interface virtual-template number —
Configure the PAP username and
password sent from the local
device to the peer when the local
device is authenticated by the peer
by using PAP
ppp pap local-user username
password { cipher | simple }
password
Required
By default, when being
authenticated by the peer using
PAP, the local device sends null
username and password to the
peer.
Configuring CHAP authentication
According to whether the authenticator is configured with a username or not, the configuration of CHAP
authentication falls into the following two types:
Configuring CHAP authentication when the authenticator name is configured
1. Configuring the authenticator
Follow these steps to configure the authenticator:
To do… Use the command… Remarks
Enter system view system-view —
Create a VT interface and enter VT
interface view
interface virtual-template number —
Configure the local device to
authenticate the peer using CHAP ppp authentication-mode chap
[ [ call-in ] domain isp-name ]
Required
By default, PPP authentication is
disabled.