H3C Technologies H3C SecPath F1000-E User Manual
Page 42
26
# Create the Layer 3 aggregate interface Route-Aggregation 1, configure it to perform load sharing
based on source IP address, and configure an IP address and subnet mask for the aggregate interface.
[DeviceA] interface route-aggregation 1
[DeviceA-Route-Aggregation1] link-aggregation load-sharing mode source-ip
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
[DeviceA-Route-Aggregation1] quit
# Assign the Layer 3 Ethernet interfaces GigabitEthernet 0/1 and GigabitEthernet 0/2 to aggregation
group 1.
[DeviceA] interface gigabitethernet 0/1
[DeviceA-GigabitEthernet0/1] port link-aggregation group 1
[DeviceA-GigabitEthernet0/1] quit
[DeviceA] interface gigabitethernet 0/2
[DeviceA-GigabitEthernet0/2] port link-aggregation group 1
[DeviceA-GigabitEthernet0/2] quit
# Create the Layer 3 aggregate interface Route-Aggregation 2, configure its link aggregation group to
perform load sharing based on destination IP address, and configure an IP address and subnet mask for
the aggregate interface.
[DeviceA] interface route-aggregation 2
[DeviceA-Route-Aggregation2] link-aggregation load-sharing mode destination-ip
[DeviceA-Route-Aggregation2] ip address 192.168.2.1 24
[DeviceA-Route-Aggregation2] quit
# Assign the Layer 3 Ethernet interfaces GigabitEthernet 0/3 and GigabitEthernet 0/4 to aggregation
group 2.
[DeviceA] interface gigabitethernet 0/3
[DeviceA-GigabitEthernet0/3] port link-aggregation group 2
[DeviceA-GigabitEthernet0/3] quit
[DeviceA] interface gigabitethernet 0/4
[DeviceA-GigabitEthernet0/4] port link-aggregation group 2
[DeviceA-GigabitEthernet0/4] quit
Step2
Configure Device B
Configure Device B using the same instructions that you used to configure Device A.
Step3
Verify the configurations
# Display summary information about all aggregation groups on Device A.
[DeviceA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG Partner ID Select Unselect Share
Interface Mode Ports Ports Type
-------------------------------------------------------------------------------
RAGG1 S none 2 0 Shar