Configuration procedure, Wlan service configuration example (on a fat ap), Network requirements – H3C Technologies H3C MSR 50 User Manual

Page 31

1-30

Figure 1-20 802.11n configuratio

Configuration procedure

# Configure a WLAN-ESS interface.

system-view

[AC] interface wlan-ess 1

[AC-WLAN-ESS1] quit

# Configure a service template and bind the WLAN-ESS interface with the service template.

[AC] wlan service-template 1 clear

[AC-wlan-st-1] ssid abc

[AC-wlan-st-1] bind WLAN-ESS 1

[AC-wlan-st-1] authentication-method open-system

[AC-wlan-st-1] service-template enable

[AC-wlan-st-1] quit

# Configure the AP on the AC.

[AC] wlan ap ap1 model WA2610E-AGN

[AC-wlan-ap-ap1] serial-id 210235A29G007C000020

# Configure the radio of the AP to operate in 802.11g/n mode.

[AC-wlan-ap-ap1] radio 1 type dot11gn

# Configure the working bandwidth of the radio as 40MHz.

[AC-wlan-ap-ap1-radio-1] channel band-width 40

[AC-wlan-ap-ap1-radio-1] service-template 1

[AC-wlan-ap-ap1-radio-1] radio enable

WLAN Service Configuration Example (on a FAT AP)

Network requirements

As shown below, a fat AP is connected to a Layer 2 switch. The IP address of the fat AP is

10.18.1.10.

It is required to configure WLAN service on the FAT AP.

Figure 1-21 Network diagram for WLAN service configuration

IP network

L2 switch

FAT AP

Client