H3C Technologies H3C MSR 50 - Manual (Page 22)

1-21
To do… Use the command… Remarks
Specify the bandwidth mode
for the radio
channel band-width { 20 | 40 }
Optional
By default, the radio operates
in 20 MHz mode.
Enable access permission for
802.11n clients only
client dot11n-only
Optional
By default, an 802.11a/n radio
permits both 802.11a and
802.11n clients to access, and
an 802.11g/n radio permits
both 802.11g and 802.11n
clients to access.
Enable the short GI function short-gi enable
Optional
Enabled by default.
Enable the A-MSDU function a-msdu enable
Optional
Enabled by default.
Enable the A-MPDU function a-mpdu enable
Optional
Enabled by default.
Enable the radio radio enable
Required
Disabled by default.
Before enabling the radio, you
must configure the Modulation
and Coding Scheme (MCS).
For mandatory and supported
802.11n rates, refer to WLAN
RRM Configuration in the
WLAN Volume.
For information about Modulation and Coding Scheme (MCS) index and mandatory and supported
802.11n rates, refer to WLAN RRM Configuration in the WLAN Volume.
Displaying and Maintaining WLAN Service
On an AC
To do… Use the command… Remarks
Display AP information
display wlan ap { all | name ap-name }
[ verbose ]
Available in any view
Display the model information
of a specified AP or all APs
supported on the AC
display wlan ap-model { all | name
ap-name }
Available in any view
Display the reboot log
information of an AP display wlan ap reboot-log name
ap-name
Available in any view
Display WLAN radio policy
information display wlan radio-policy
[ radio-policy-name ]
Available in any view