H3C Technologies H3C MSR 50 - Manual (Page 16)

1-15
crypto type. If a clear type service template exists, you cannot change it to crypto. To do so, you must
delete the clear type service template, and configure a new service template with type as crypto.
Follow these steps to configure a service template:
To do… Use the command… Remarks
Enter system view system-view —
Create a WLAN-ESS interface
interface wlan-ess
interface-index
—
Support for this command
depends on the device model.
This command is only
supported on ACs.
Exit interface view quit —
Create a WLAN service
template and enter WLAN
service template view wlan service-template
service-template-number { clear |
crypto } Required
No WLAN service template is
created by default.
Specify the service set
identifier
ssid ssid-name
Required
By default, no SSID is set.
Disable the advertising of
SSID in beacon frames
beacon ssid-hide
Optional
By default the SSID is
advertised in beacon frames.
Note that hiding the SSID
does very little to increase
security.
Bind the WLAN-ESS interface
to the service template
bind wlan-ess interface-index
Required
By default, no interface is
bound to the service template.
Support for this command
depends on the device model.
This command is only
supported on ACs.
Enable local forwarding
client forwarding-mode local
[ vlan vlan-id-list ]
Optional
Remote forwarding is enabled
by default.
This command is only
supported on ACs.
Specify an authentication
method authentication-method { open
system | shared key }
Required
For related configuration
about the shared key, refer to
WLAN Security in the WLAN
Volume.
Specify the maximum
associated clients per BSS
client max-count max-number
Optional
64 by default.
Enable the service template service-template enable
Required
Disabled by default.