H3C Technologies H3C MSR 50 - Manual (Page 15)

1-14
To do… Use the command… Remarks
Specify the uplink interface
wlan uplink-interface
interface-type
interface-number
Optional
By default, no interface is
configured as an uplink
interface.
Specifying a Country Code
A country code identifies the country in which you want to operate radios. It determines characteristics
such as operating power level and total number of channels available for the transmission of frames.
You must set the valid country code or area code before configuring an AP.
Follow these steps to specify the country code:
To do… Use the command… Remarks
Enter system view system-view —
Specify the country code wlan country-code code
By default, the country code is
CN.
For information about country codes, refer to WLAN Services Command in the WLAN Volume.
Configuring Software Version Automatic Update
A fit AP is a zero-configuration device. It can automatically discover an AC after power-on. To ensure
that a fit AP can associate with an AC, their software versions must be consistent by default, which
complicates maintenance. This task allows you designate the software version of an AP on the AC, so
that they can associate with each other even if their software versions are inconsistent.
Follow these steps to configure software version automatic update:
To do… Use the command… Remarks
Enter system view system-view —
Designate the software version
of a given AP model with a
given hardware version wlan apdb model-name
hardware-version
software-version
Optional
By default, the software version
will be the value initialized by
the driver, namely, the software
versions of the fit AP and the
AC should be consistent.
Configuring a WLAN Service Template
A WLAN service template includes attributes such as SSID, WLAN-ESS interface binding,
authentication method (open-system or shared key) information. A service template can be of clear or