H3C Technologies H3C MSR 50 - Manual (Page 25)

1-24
To do… Use the command… Remarks
Return to system view quit —
Enable the user profile user-profile profile-name enable
Required
Not enabled by default.
Note that:
The name of the user profile
must be identical to that of the
external group on the RADIUS
server.
To support roaming, all ACs in
a mobility group must have the
same profile name configured.
For more information about user profile, refer to User Profile Configuration in the System Volume.
Displaying and Maintaining AP Group
To do… Use the command… Remarks
Display AP group information display wlan ap-group [ value ] Available in any view
Configuring SSID-Based Access Control
When a user wants to access a WLAN temporarily, the administrator can specify a permitted SSID in
the corresponding user profile so that the user can access the WLAN only through the SSID.
Specifying a Permitted SSID in a User Profile
After completing the configuration, the user profile needs to be enabled to take effect.
Follow these steps to specify a permitted SSID:
To do… Use the command… Remarks
Enter system view system-view —
Enter user profile view user-profile profile-name
Required
If the specified user profile does
not exist, this command will
create it and enter its view.
Specify a permitted
SSID
wlan permit-ssid ssid-name
Required
No permitted SSID is specified
by default, that is, users can
access the WLAN without SSID
limitation.
Return to system view quit —