H3C Technologies H3C S5500 Series Switches - Manual (Page 40)

32
Figure 25 Front and rear mounting bracket installation (2)
(1) Load-bearing screw (2) Rear mounting bracket
(3) Front panel (4) Screw used to attach front mounting brackets to front brackets
(5) Front mounting bracket (6) Front square-holed post
Mounting the switch on a workbench
In many cases, standard 19-inch racks are not available. Switches are often placed on clean
workbenches. To place the switch on a workbench, follow these steps:
1. Place the switch with bottom up carefully, and then clean the round holes on the chassis bottom
with dry cloth.
2. Attach the rubber feet to the four round holes on the chassis bottom.
3. Place the switch with upside up on the workbench.
During the operation, you simply need to:
• Make sure the workbench is flat and sturdy.
• Ensure good ventilation and a space of 10 cm (3.94 in) around the chassis for heat dissipation.
• Avoid heavy objects on the switch.