H3C Technologies H3C S5500 Series Switches - Manual (Page 16)

8
Figure 9 Rear panel of the S5500-28C-PWR-EI switch (PoE+ model)
(1) RPS power input (2) AC power input
(3) Grounding screw (4) Interface card slot 1 (MOD1)
(5) Interface card slot 2 (MOD2) (6) PoE+ label
Figure 10 Rear panel of the S5500-28C-PWR-EI switch (PoE model)
(1) RPS power input (2) AC power input
(3) Grounding screw (4) Interface card slot 1 (MOD1)
(5) Interface card slot 2 (MOD2)
NOTE:
The S5500-28C-PWR-EI is shipped with the two expansion interface card slots covered by filler panels.
You can select one or two interface cards for your switch as needed. For the interface cards available for
the S5500-EI Switch Series, see "
Interface cards ." For how to install an interface card, see " Installing and
removing an interface card ."
S5500-52C-PWR-EI
S5500-52C-PWR-EI includes two models: PoE and PoE+.
• The front panels of the PoE and PoE+ models are the same in appearance. See Figure 11 .
• The PoE+ model has a PoE+ label on its rear panel, as shown in Figure 12 . The maximum PoE power
per port is 30 W.
• The PoE model has no PoE+ label on its rear panel, as shown in Figure 13 . The maximum PoE power
per port is 15.4 W.
For more information about the PoE power supply, see Table 2 .