H3C Technologies H3C S5500 Series Switches - Manual (Page 37)

29
Figure 21 Attaching front mounting brackets and load-bearing screws
(1) Load-bearing screw (2) Optional positions for load-bearing screw
(3) Front panel (4) Front mounting bracket
(5) Screw used to attach front mounting brackets to the switch
NOTE:
The switch provides three positions (except the S5500-28F-EI, which provides two positions) to mount a
load-bearing screw on both sides. Select a proper position according to the actual requirements. The rear
mounting brackets tightly contacted with the load-bearing screws can support the switch.
5. Select a position to install the switch and attach the rear mounting brackets to the rear posts with
screws and cage nuts, as shown in
Figure 22 .
Figure 22 Attaching rear mounting brackets
(1) Rear square-holed post (2) Rear mounting bracket
6. Support the bottom of the switch with one hand and the front part of the switch with the other hand,
and push the switch into the rack gently, as shown in
Figure 23 .
(5)
(1)
(2)
(4)
(3)