Setting new main and backup system software images – H3C Technologies H3C S7500E Series Switches User Manual

Page 29

Figure 8 The Xmodem file send for Switch dialog box

28.

When the file is successfully downloaded, the following information appears:

Loading ...CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC.done!

Free flash Space : 65932288 bytes

Writing flash...................................................................

........................................................................

.........done!

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):

29.

Type 0 to return to the boot menu.

NOTE:

When the system reboots, you must change the baud rate for HyperTerminal back to 9600 bps by
following Step 6 and Step 7.

Setting new main and backup system software images

After you download a new system software image to the switch, set the file as the main or backup system

software image.