Using an upgrade file on the switch – H3C Technologies H3C S7500E Series Switches User Manual
Page 22
21
Enter your choice(0-5):0
14.
Type 0 to reboot the switch.
NOTE:
After the reboot, you must change the baud rate for HyperTerminal back to 9600 bps by following Step 5
and Step 6.
Using an upgrade file on the switch
1.
Connect the console port of the switch to a PC.
2.
Run the terminal emulation program on the PC. Start the switch, enter the boot menu (see
for more information), and press Ctrl+U when you see "Enter your choice(0-5):" to enter the
Boot ROM update menu.
BootRom update menu:
1. Set TFTP protocol parameters
2. Set FTP protocol parameters
3. Set XMODEM protocol parameters
4. Update through file in device
0. Return to boot menu
Enter your choice(0-4):
3.
In the Boot ROM update menu, type 4. The following information appears:
Flash:/
Number. Size(B) Time Name
===============================================================================
1 5732 Aug/17/2010 19:20:10 private-data.txt
2 8172 Aug/17/2010 19:21:05 startup.cfg
3(*-) 27451869 Jul/29/2010 17:35:17 switch000.app
4 27455679 Jul/29/2010 17:35:17 update.btw
5 151 Aug/17/2010 19:20:21 system.xml
6 429516 Aug/19/2010 15:59:51 mpu.btw
7 7938 May/10/2010 13:59:11 config.cfg
Free space: 37154816 bytes
The current application file is:flash:/switch000.app
The backup application file is:flash:/switch000.app
Please input the file number:4
4.
Type the number of the target .app file. The following information appears:
The file you selected is flash:/update.btw, update from it? Yes or No(Y/N)Y
5.
Answer Y to the question. The following information appears:
Load file from flash to sdram......done!
The file you selected is not the primary boot file, are you sure you want to
update from it? Yes or No(Y/N)Y
6.
Answer Y to the question. The following information appears:
Will you Update Basic BootRom? (Y/N):
7.
Answer Y to the question. The following information appears: