H3C Technologies H3C S7500E Series Switches - Manual (Page 76)

8-3
Traffic direction (right)
Card category (below)
Inbound Outbound
SD Supported Supported
Traffic Filtering Configuration Example
Traffic Filtering Configuration Example
Network requirements
As shown in Figure 8-1 , Host is connected to GigabitEthernet 2/0/1 of Device.
Configure traffic filtering to filter the packets whose source port is 21 received on GigabitEthernet 2/0/1.
Figure 8-1 Network diagram for traffic filtering configuration
Configuration procedure
# Create advanced ACL 3000, and configure a rule to match packets whose source port number is 21.
system-view
[DeviceA] acl number 3000
[DeviceA-acl-basic-3000] rule 0 permit tcp source-port eq 21
[DeviceA-acl-basic-3000] quit
# Create a class named classifier_1, and reference ACL 3000 in the class.
[DeviceA] traffic classifier classifier_1
[DeviceA-classifier-classifier_1] if-match acl 3000
[DeviceA-classifier-classifier_1] quit
# Create a behavior named behavior_1, and configure the traffic filtering action for the behavior to
drop packets.
[DeviceA] traffic behavior behavior_1
[DeviceA-behavior-behavior_1] filter deny
[DeviceA-behavior-behavior_1] quit
# Create a policy named policy, and associate class classifier_1 with behavior behavior_1 in the
policy.
[DeviceA] qos policy policy
[DeviceA-qospolicy-policy] classifier classifier_1 behavior behavior_1
[DeviceA-qospolicy-policy] quit
# Apply the policy named policy to the incoming traffic of GigabitEthernet 2/0/1.
[DeviceA] interface gigabitethernet 2/0/1
[DeviceA-GigabitEthernet2/0/1] qos apply policy policy inbound