H3C Technologies H3C S7500E Series Switches - Manual (Page 60)

5-8
Configuration Example
Configure GTS on GigabitEthernet2/0/1, shaping the packets of queue 1 when the sending rate
exceeds 512 kbps.
# Enter system view.
system-view
# Enter interface view.
[Sysname] interface gigabitethernet 2/0/1
# Configure GTS parameters.
[Sysname-GigabitEthernet2/0/1] qos gts queue 1 cir 512
Configuring the Line Rate
Configuration Procedure
Follow these steps to configure the line rate:
To do… Use the command… Remarks
Enter system view system-view —
Enter
interface
view
interface interface-type interface-number
Enter
interface
view or port
group view
Enter port
group view
port-group manual port-group-name
Use either command
Settings in interface view take effect
on the current interface; settings in
port group view take effect on all
ports in the port group.
Configure the inbound or
outbound line rate for the
interface/port group
qos lr outbound cir
committed-information-rate [ cbs
committed-burst-size ]
Required
z On SC, SA, and EA LPUs, the
granularity of line rate is 64 kbps.
z On SD and EB LPUs, the
granularity of line rate is 8 kbps.
Display line rate
configuration information
on the interface/all
interfaces
display qos lr interface [ interface-type
interface-number ]
Available in any view
Configuration Example
Limit the outbound line rate of GigabitEthernet 2/0/1 to 512 kbps.
# Enter system view.
system-view
# Enter interface view.
[Sysname] interface gigabitethernet 2/0/1