H3C Technologies H3C S12500 Series Switches - Manual (Page 51)

43
Figure 18 Network diagram
Configuration procedure
1. Configure Device A:
# Set the member ID 1 to Device A, and bind port Ten-GigabitEthernet 3/0/1 to IRF-port 2.
system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the switch reboots and operates in IRF
mode.
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port2] quit
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
# Specify the priority of Device A as 12 to make sure it is elected as the master when the IRF fabric
is established.
[Sysname] irf priority 12
# Save the configuration.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait.....................................
The current configuration is saved to the active main board successfully.
Configuration is saved to device successfully.