Enabling auto reboot for irf fabric merge, Configuring a member device description – H3C Technologies H3C S12500 Series Switches User Manual
Page 35

27
To enable enhanced IRF mode:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable enhanced IRF mode.
irf mode enhanced
By default, enhanced IRF
mode is disabled.
After the enhanced IRF mode
is enabled, you cannot create
Layer 3 Ethernet interfaces or
subinterfaces or Layer 3
aggregation interfaces or
subinterfaces.
Enabling auto reboot for IRF fabric merge
When two IRF fabrics merge, you must reboot the member devices in the IRF fabric that fails in the master
election. The auto reboot function enables the IRF fabric to automatically reboot all its member devices to
complete the merge.
This function can work only when it is enabled on both IRF fabrics that are merging.
This function does not take effect on the IRF fabric merge caused by binding a physical port to an IRF port
in IRF mode. You must manually reboot the devices that have failed in the master selection to complete
the merge.
To enable auto reboot for IRF fabric merge:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable auto reboot for IRF
fabric merge.
irf auto-merge enable
Optional.
By default, this function is
disabled.
Configuring a member device description
You can configure a description to describe the location or purpose of a member device.
To configure a description for a member device:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the description of
a member.
irf member member-id description text
Optional.
By default, no member device
description is configured.