Ensemble Designs 6040 Tracking Audio Delay - Manual (Page 22)

• Sampling Freq – displays the sampling frequency of the input signal pair from
one of the following values:
• 48 kHz
• 44.1 kHz
• 32 kHz
• Non-std (sampling frequency is not any of the above frequencies)• A.
Out Stat – indicates the current state of the analog outputs as one of the
following:
• Normal (analog outputs are operating normally)
• Muted (analog outputs are muted when a non-audio source is being used on
the digital input)
• Ext In – box indicates the external input status from one of two colors:
• Black (no signal present)
• Green (valid signal present)
• I/P Error – one of two colors will display to indicate the AES input status:
• Black (signal is present)
• Red (no valid input present)
• Emph – one of two colors will display to indicate the AES emphasis state:
• Black (no emphasis detected)
• Yellow (50/15 µS emphasis detected. If emphasis is detected, the 6040 will
set the emphasis bits on the AES outputs and apply de-emphasis on the
analog outputs.)
• DSP – box will display one of the following three colors to indicate the operating
state of the Digital Signal Processor:
• Black (DSP is running but not ready, should only occur at start-up)
• Green (DSP is running normally)
• Red (DSP error)
• PLL – box will indicate one of the following two colors to indicate the operating
state of the Phase Lock Loop:
• Green (PLL is operating correctly)
• Red (flashing indicates PLL error)
Model 6040 Tracking Audio Delay
6040-22