beautypg.com

Ensemble Designs 5400 Dual Sync Generator and Test Signal Generator with HD Tri-Level Sync User Manual

Page 14

background image

Front Panel Controls and Indicators

Each front edge indicator and switch setting is shown in the diagram below:

5400-14

Remote/Local switch:
Set to the mode you
will be using.

Pwr green LED:
Indicates the presence (ON) or
absence (OFF) of power (+5V).

Run green LED:
OFF:
A power fault or halted CPU
ON:
A halted CPU
FAST BLINK:
CPU Run error
SLOW BLINK:
System OK. (If SPI control is
active from the main frame
System Control Module, all
Run indicators will be syn-
chronized.).

Ref 525, 625 and 10 MHz
green LEDs:
One LED will light to indicate
which reference rate is currently
being detected.
OFF when rate is not detected.

Pri 525/625 green LEDs:
One LED will light to indicate
the Primary output line standard
and that it is locked to its timing
source.
If no LED is lit, the Primary
generator is not locked to its
timing source.

Model 5400 Dual Sync Gen/Test Signal Generator

Sec 525/625 green LEDs:
One LED will light to indicate
the Secondary output line
standard and that it is locked to
its timing source.
If no LED is lit, the Secondary
generator is not locked to its
timing source.

Error red LED:
Indicates a genlock or
synchronization problem.

Ref (Reference)
Internal/GL
switch:
Set the reference source to Internal
(left) or GL, Genlock, (right) if using
the external reference input as the
timing source.
Pri (Primary Generator)
525/625
switch:
Set the Primary output line rate to
525 (left) or 625 (right).
Aud Insert switch:
Set the switch to On (left) to embed
an audio tone into the Primary serial
output or Off (right) for no tone
Sec (Secondary Generator)
525/625
switch:
Set the Secondary generator output
line rate to 525 (left) or 625 (right).
HD (High Definition)
1080/720p
switch:
Set to either 1080 (left) or 720p
(right) for the type of tri-level HD
sync output desired.
1080i/sF switch:
For 1080 signals, select either
1080i (left) for interlaced or 1080sF
(right) for segmented frame.
(Note: The frame rate will match the
Primary.)

This manual is related to the following products: